Details, datasheet, quote on part number: TLK2208AZPV
PartTLK2208AZPV
Category
Description8-port Gigabit Ethernet Transceiver
CompanyTexas Instruments, Inc.
DatasheetDownload TLK2208AZPV datasheet
Quote
Find where to buy
 
  

 

Features, Applications

(Gbps) Synchronizable Transceivers Low Power Consumption at 1.25 Gbps IEEE 802.3z Gigabit Ethernet Compliant Differential VML Transmit Outputs With No External Components Necessary. PECL Compatible Levels Programmable High-Speed Output Preemphasis Levels Selectable Parallel Interface Modes: - Nibble-Wide Double Data Rate (DDR) Clocking Interface - Multiplexed Channel DDR Clock Interface Selectable Clock Tolerance Compensation Selectable On-Chip 8b/10b IEEE 802.3z Compliant Encoder and Decoder JEDEC-Compliant 1.8-V LVCMOS (Extendable 2.5 V)

D 3.6-V Tolerant Inputs on Parallel I/O D Internal Series Termination on LVCMOS D Comprehensive Suite of Built-In

Outputs to Drive 50- Lines Testability Features (PRBS Generation and Verification, Serial Loopback, and Far-End Loopback) IEEE 802.3 Clause 22 Management Data Interface (MDIO) Support IEEE 1149.1 JTAG Support Hot-Plug Protection on Serial I/O No External Filter Components Required for PLLs Small Footprint 289-Terminal, 1,0-mm Ball-Pitch BGA Advanced Low-Power 0.18-m CMOS Technology Commercial Temperature Rating to 70C)

description

The TLK2208A is the third generation of Gigabit Ethernet transceivers from Texas Instruments combining high port density and ultralow power in a small form-factor footprint. The TLK2208A provides for high-speed full-duplex point-to-point data transmissions based on the IEEE 802.3z 1000-Mbps Ethernet specification. The TLK2208A supports data rates from 1.0 Gbps through 1.3 Gbps. The primary application of this device is to provide building blocks for developing point-to-point baseband data transmission over controlled impedance media of 50. The transmission media can be printed circuit board traces, copper cables or fiber-optical interface modules. The ultimate rate and distance of data transfer is dependent upon the attenuation characteristics of the media and the noise coupling to the environment. The TLK2208A performs the data encoding, decoding, serialization, deserialization, clock extraction, and clock tolerance compensation functions for a physical layer interface device. Each channel operates to 1.3 Gbps providing to 8.32 Gbps of aggregate data bandwidth over copper or optical-media interfaces. The TLK2208A supports two selectable reduced-pin-count double-data-rate (DDR) timing interfaces, nibble mode and multiplexed channel mode, to a protocol device. In the nibble interface mode, the parallel interface accepts nibble-wide unencoded or 8b/10b encoded data aligned to both the rising and falling edges of the transmit clock. In the multiplexed channel mode, the parallel interface accepts 8-bit-wide unencoded 10-bit-wide 8b/10b encoded data with channels C, E, and G aligned to the falling edge of the source synchronous transmit clock and channels D, F, and H aligned to the rising edge of the transmit clock. The receive path interface is done in the same manner.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

The TLK2208A aligns the recovered data clock frequency to the reference clock on each channel by means of a clock tolerance compensation circuit and internal FIFO that inserts or drops 20-bit IDLE codes as needed in the interpacket gap (IPG). In synchronous mode, the received data for all channels is aligned to a single receive data clock that is a buffered version of the reference clock. The TLK2208A supports a selectable IEEE 802.3z compliant 8b/10b encoder/decoder in all its modes of operation.

The TLK2208A automatically locks onto incoming data without the need to pre-lock.

The TLK2208A provides a comprehensive series of built-in tests for self-test purposes including loopback and PRBS generation and verification. An IEEE 1149.1 JTAG port is also supported to aid in board-manufacturing testing. The TLK2208A is housed in a small form-factor 1919-mm, 289-terminal BGA with 1,0-mm ball pitch. The ball out and footprint are compatible with those of the PMC-Sierra PM8352 8-channel transceiver. The TLK2208A is characterized to support the commercial temperature range to 70C. The TLK2208A consumes 1.3 W when operating at nominal conditions. The TLK2208A is designed to be hot-plug capable. A power-on reset puts the serial side output signal terminals TX+/TX- in the high-impedance state during power up.

Line Card RCLK 8 RX+ RDA..H[9:0] RX- TLK2208A MAC/ Packet Processor TCLKB 8
Functionally compatible with the PM8352 in multiplex channel mode.

 

Some Part number from the same manufacture Texas Instruments, Inc.
TVP3033 Video Interface Palette
231Q1 3.3-v CAN Transceivers
UC27136 DUAL Output Switch
TPS65530_08 Fully Integrated 8-channel Dc/dc Converter FOR Digital Still Cameras
FB2033A 8-bit Ttl/btl Registered Transceiver
AFE8406 14-bit, 85 MSPS Dual ADC, 8-channel Wideband Receiver
74FCT162240ATPACT 16-bit Registered Transceivers
SNC74S114 DUAL J-K Negative-edge-triggered Flip-flops WITH Preset, Common Clear, AND Common Clock
LT1037MJG Low-noise, High-speed, Precision Operational Amplifiers
TM497FBK32S Extended DATA OUT Dynamic RAM Modules
SE370C686AYYZ Tms370 Microcontroller Family DATA BOOK
LM337KVURG3 3-terminal Adjustable Regulators
TXS0101 1-bit Bidirectional Voltage-level Translator FOR Open-drain AND Push-pull Applications
UC3864J Resonant-mode Power Supply Controllers
ADS7865I Dual, 12-bit, 3+3 or 2+2 Channel, Simultaneous Sampling Analog-to-digital Converter
RF-HDT-DVBE-N0_07 13.56 MHz Vicinity Key Fob Transponder
TBP28S42J Standard AND LOW Power Programmable Read-only Memories
TLC2274ACDG4 Advanced Lincmos Rail-to -rail Operational Amplifiers

AM26LV31CDR : ti AM26LV31, Low-voltage High-speed Quadruple Differential Line Driver

LM139AFKB : ti LM139A, Quad, General Purpose Differential Comparator

LT1081 : Advanced Low-power 5v Dual Eia-232 Driver/receivers

TLV431ACLPR : ti TLV431A, Low Voltage Adjustable Precision Shunt Regulator

TL52055D : WIDE Bandwidth 2 Input 1 Output 3-circuit Video Switch

SN74CBT3257DBRE4 : 11-bit 1-of-4 FET Multiplexer/demultiplexer 1.8-v Ddr-ii Switch WITH Charge PUMP AND Precharged Outputs

CLVTH16244AIDGVREP : Logic - Buffers, Drivers, Receivers, Transceiver Integrated Circuit (ics) Buffer/Line Driver, Non-Inverting Cut Tape (CT) 24mA, 24mA 2.7 V ~ 3.6 V; IC BUFF/DVR TRI-ST 16BIT 48TSSOP Specifications: Logic Type: Buffer/Line Driver, Non-Inverting ; Package / Case: 48-TFSOP (0.240", 6.10mm Width) ; Packaging: Cut Tape (CT) ; Mounting Type: Surface Mount ; Number of Bits per Element: 4 ; Number of Elements: 4 ; Operating Temperature: -55C ~ 125C ; Voltage - Supply: 2.7 V ~ 3.6 V ;

REG1117FA-5.0KTTT : ti REG1117A, 800mA And 1A Low Dropout (LDO) Positive Regulator 1.8V, 2.5V, 2.85V, 3.3V, 5V, And Adj

74AHCT1G86DCKRE4 : Logic - Gate And Inverter Integrated Circuit (ics) XOR (Exclusive OR) Tape & Reel (TR) 8mA, 8mA 4.5 V ~ 5.5 V; IC SNGL 2IN EX-OR GATE SC70-5 Specifications: Number of Circuits: 1 ; Package / Case: 6-TSSOP (5 Lead), SC-88A, SOT-353 ; Logic Type: XOR (Exclusive OR) ; Packaging: Tape & Reel (TR) ; Mounting Type: Surface Mount ; Number of Inputs: 2 ; Current - Output High, Low: 8mA, 8mA ; Operating Temperature: -40C ~ 85C ; Voltage - S

CD74HCT652M96E4 : Registered Transceivers ti CD74HCT652, High Speed CMOS Logic Octal Bus Transceivers/registers With 3-State Outputs

TPS51020EVM-001 : Eval Board - Dc/dc & Ac/dc (off-line) Smp Programmers, Development System; EVAL MODULE FOR TPS51020-001 Specifications: Board Type: Fully Populated ; Main Purpose: DC/DC, Step Down ; Regulator Topology: Buck ; Outputs and Type: 2, Non-Isolated ; Voltage - Output: 3.3V, 5V ; Current - Output: 6A, 6A ; Voltage - Input: 8 ~ 20 V ; Frequency - Switching: 300kHz ; Power - Output: - ; Utilized IC / Part: TP

TPS25921EVM-637 : Power Management IC Development Tools TPS25921 Eval Mod Texas Instruments TPS25921x eFuse with Precision Current Limit is a compact, feature rich eFuse with a full suite of protection functions. The wide operating voltage allows control of many popular DC buses. The precise 2% current limit, at room temperature, provides excellent accuracy making the

 
0-C     D-L     M-R     S-Z