Details, datasheet, quote on part number: TFB2002BPPM
PartTFB2002BPPM
CategoryInterface and Interconnect => Line Drivers/Interfaces => Standard Line Circuits
TitleStandard Line Circuits
Descriptionti TFB2002B, Futurebus+ I/o Controller
CompanyTexas Instruments, Inc.
DatasheetDownload TFB2002BPPM datasheet
Quote
Find where to buy
 
  

 

Features, Applications

Industrial Temperature Version of the TFB2002B With an Operating Range to 85C Provides Control Logic Necessary to Operate a Data Path Unit (TFB2022A) on Futurebus+ Parallel-Protocol Support Is Fully Compliant to Futurebus+ Standard (IEEE Std 896.11991) Interfaces Easily to a Variety of Popular Microprocessors Such as SPARCTM, 88xxx, 80x86, and Alpha AXPTM

Provides Full Support for Futurebus+ Cache Commands (for Memory or I/O Modules in Shared-Memory Systems) Capable of Handling a Single Outstanding Split Transaction Parallel-Protocol-Related CSR Locations Are Provided on Chip Offers Autonomous Control for Futurebus+ and Host-Module Reads and Writes

description

The TFB2002BI I/O controller (IOC) is a member of the Texas Instruments Futurebus+ (FB+) chip set. This chip set provides a highly integrated approach to the Futurebus+ interface that reduces new-product design time, allows more functionality per circuit board, improves overall interface reliability, and reduces end-user down time through built-in test capabilities. The Futurebus+ chip set is capable of supporting or 64-bit data widths in any combination on both the host-bus interface (HIF) and Futurebus+. The address width is programmable be 32 bits or 36 bits (with either data width). The TFB2002BI contains the control logic necessary to translate Futurebus+ transactions into host bus transactions and vice versa. It contains a high-speed Futurebus+ handshake controller, a synchronous host bus controller, and reset-type determination logic. When combined with a TFB2022A Futurebus+ data path unit (DPU), the TFB2002BI provides a complete 64-bit-wide interface to the Futurebus+. The TFB2002BI provides the necessary control logic for the data path unit to provide a complete interface to the Futurebus+ for a Profile-B-compliant module. It may also be used on I/O or memory modules in a cache-coherent system. The TFB2002BI is offered a 208-pin plastic quad flat package (PPM). The TFB2002BI is characterized for operation over the industrial temperature range to 85C.

NOTE: To maintain consistency with the notation used in the Futurebus+ standard (IEEE Std 11991), an active-low signal is denoted herein by use of the trailing asterisk on the signal name. SPARC is a trademark of Sun Microsystems, Inc. Alpha AXP is a trademark of Digital Equipment Corporation.

PRODUCTION DATA information is current as of publication date. Products conform to specifications per the terms of Texas Instruments standard warranty. Production processing does not necessarily include testing of all parameters.

TSIZE1 TSIZE0 HSTRB* Vcc HMODE1 HMODE0 GND HADEC2 HADEC1 Vcc HADEC0 HAS* HIP* GND DMAMODE DATAAV* SPACEAV* Vcc NEWADDR* TR/W* DL1 GND DSACK1* DSACK0* Vcc FADEC2 FADEC1 GND FMODE2 FMODE1 Vcc FMODE0 FRD* FSTRB GND FACK SELECTED* BSTRDY* Vcc ADRCV ADDRV* GND STO7 STI7 GND STO6 STI6 POST OFFICE BOX 655303

TERMINAL NAME BSTAT< 1:0 NO. 206 207 I/O FROM/TO Host interface Host-interface status: LH LL I/O I I/O Host interface Host interface Host interface Normal Reserved Bus error Backoff/retry B k ff/ t DESCRIPTION

Burst ready Clock input. CLK is the processor clock for synchronous transactions on the host side. to 25 MHz is recommended. Host-interface data length: HH 64 bytes y 32 bytes 16 bytes 8 bytes b t Burst mode (TBST* = low): HL HH speed, 32-bit capable Low s eed, 32 bit burst ca able g speed, , 32-bit burst capable High Low speed, 64-bit burst capable High speed, 64-bit burst capable

Data acknowledge: Single mode (TBST* = high): HL HH Complete Com lete cycle, data bus port 32 Reserved Insert wait state

DW64* HAS* HBG* HBGACK* HBR* HDS* HIP* IGNORE*

Host interface Host interface Host interface Host interface Host interface Host interface Host interface Host interface

Host-interface data width of 64 (burst mode only) Host-interface address strobe Host-interface grant input Host-interface grant acknowledge Host-interface request output Host-interface data strobe Host-interface transaction in progress Ignore the current host transaction input. IGNORE* is supplied by the hostmemory decoder when an access to private memory occurs. IGNORE* is optional and should be tied high it is not used. Host interrupt output. When an enabled interrupt condition occurs, INT* is driven low. Interrupts are cleared by writing a one to the appropriate bit in the interrupt register. The interrupt goes high during the write cycle to the interrupt register even if another interrupt is pending. Also used from FB+ 2:0 > lines to a mastered HIF locked operation. These terminals are used as inputs when the IOC is a host-interface slave/FB+ master. Host cycle is locked (indivisible) Locked-command bits passed from the host interface to FB+ or from FB+ to the host interface via the 2:0 > lines during a mastered FB+ data phase in a locked operation. Also used from FB+ 2:0 > lines to a mastered HIF locked operation. These terminals are used as inputs when the IOC is a host interface slave/FB+ master.


 

Related products with the same datasheet
TFB2002BMHFHB
Some Part number from the same manufacture Texas Instruments, Inc.
TFB2010 Futurebus+ Arbitration Bus Controller
TFB2010MHSB ti TFB2010, Futurebus+ Arbitration Bus Controller
TFB2022AI Futurebus+ Data Path Unit
TFB2022AMFP ti TFB2022A, Futurebus+ Data Path Unit
TFP101 ti Panelbus(tm) Digital Receiver
TFP101A
TFP101APZP ti TFP101A, Panelbus Dvi Receiver 86MHz, HSYNC Fix
TFP101PZP ti TFP101, Panelbus Dvi Receiver 86MHz
TFP201 ti Panelbus(tm) Digital Receiver
TFP201A
TFP201APZP ti TFP201A, Panelbus Dvi Receiver 112MHz, HSYNC Fix
TFP201PZP ti TFP201, Panelbus Dvi Receiver 112MHz
TFP401 ti Panelbus(tm) Digital Receiver
TFP401A
TFP401APZP ti TFP401A, Panelbus Dvi Receiver 165MHz, HSYNC Fix
TFP401PZP ti TFP401, Panelbus Dvi Receiver 165MHz
TFP403
TFP403PZP ti TFP403, Panelbus Dvi Receiver
TFP410 Panelbus Dvi Transmitter 165MHz
TFP410PAP ti TFP410, Panelbus Dvi Transmitter 165MHz
TFP420

74FCT162543CTPVCT : Registered Transceivers ti CY74FCT162543T, 16-Bit Registered Transceivers With 3-State Outputs

TPS62620YFDR : 600-mA, 6-MHz High-Efficiency Step-Down Converter In Chip Scale Packaging The TPS6262x device is a high-frequency synchronous step-down dc-dc converter optimized for battery-powered portable applications. Intended for low-power applications, the TPS6262x supports up to 600mA load current, and allow

UA78L09ACDRG4 : Positive-voltage Regulators

TAS5706PAPG4 : 20-W Stereo Digital Audio Power Amplifier with EQ and DRC

CD40110 : CMOS Decade Up-down Counter/latch/display Driver

7BT2F3G-362 : HIGH Capacity Environmentally Sealed

TLV320A24KIPFBRG4 : IC, AUDIO CODEC, 16BIT, 26KHZ, TQFP-48 Specifications: Audio CODEC Type: Stereo ; No. of ADCs: 2 ; No. of DACs: 2 ; No. of Input Channels: 5 ; No. of Output Channels: 3 ; ADC / DAC Resolution: 16bit ; ADCs / DACs Signal to Noise Ratio: 92dB ; Sampling Rate: 26kSPS ; IC Interface Type: I2C, Serial ; Supply Voltage Range: 2.7V to 3.6V, 1.6

LM3S6637-EQC50-A2T : Embedded - Microcontroller Integrated Circuit (ics) Internal Tray 2.25 V ~ 2.75 V; IC ARM CORTEX MCU 128KB 100LQFP Specifications: Program Memory Size: 128KB (128K x 8) ; RAM Size: 32K x 8 ; Number of I /O: 41 ; Package / Case: 100-LQFP ; Speed: 50MHz ; Oscillator Type: Internal ; Packaging: Tray ; Program Memory Type: FLASH ; EEPROM Size: - ; Core Processor: ARM Cortex-M3 ; Data Converters: A/D 4x10b ; Core S

74ALVCH162827VRG4 : Logic - Buffers, Drivers, Receivers, Transceiver Integrated Circuit (ics) Buffer/Line Driver, Non-Inverting Tape & Reel (TR) 12mA, 12mA 1.65 V ~ 3.6 V; IC BUFF/DVR TRI-ST 20BIT 56TVSOP Specifications: Logic Type: Buffer/Line Driver, Non-Inverting ; Package / Case: 56-TFSOP (0.173", 4.40mm Width) ; Packaging: Tape & Reel (TR) ; Mounting Type: Surface Mount ; Number of Bits per Element: 10 ; Number of Elements: 2 ; Operating Temperature: -40C ~ 85C ; Voltage - Supply: 1.65 V ~

OPA356AQDBVRQ1 : Linear - Amplifier - Instrumentation, Op Amps, Buffer Amp Integrated Circuit (ics) Voltage Feedback Tape & Reel (TR) 8.3mA 1; IC OPAMP VFB R-R 200MHZ SOT23-5 Specifications: Packaging: Tape & Reel (TR) ; Amplifier Type: Voltage Feedback ; Number of Circuits: 1 ; Package / Case: SC-74A, SOT-753 ; Slew Rate: 360 V/s ; Gain Bandwidth Product: 200MHz ; Current - Supply: 8.3mA ; Current - Output / Channel: 100mA ; Voltage - Supply, Single/Dual (): 2.5 V

 
0-C     D-L     M-R     S-Z