|Category||Analog & Mixed-Signal Processing|
|Description||Video & Sound if System|
|Company||ST Microelectronics, Inc.|
|Datasheet||Download TDA8213 datasheet
VERY LOW CURRENT ABSORPTION 3 STAGE IF GAIN CONTROLLED AMPLIFIER SYNCHRONOUS VIDEO DEMODULATOR WHITE SPOT AND NOISE INVERTER AGC CIRCUIT WITH NOISE GATING TUNER AGC OUTPUT FOR PNP TUNERS FM DETECTOR AF AMPLIFIER WITH DC VOLUME CONTROL AFC 2 VPP ON VIDEO OUTPUT
DESCRIPTION The is a monolithic integrated circuit in DIP20 package for colour and black & white television receivers using PNP tuners. It is intended to operate with a negatively modulated vision carrier and frequency modulated sound carrier. Used with TDA8214/15 (H/V deflection circuit) and TDA8217 (Pal decoder and video processor), this IC permits a complete low-cost solution for PAL applications. PIN CONNECTIONS
TUNER DELAY RESISTOR TUNER OUTPUT CURRENT V CC NOT TO BE CONNECTED IF INPUT IF INPUT GROUND AUDIO OUTPUT SOUND VOLUME CONTROL FM TANK LC
AGC MEMORY CAPACITOR IF LC VIDEO PEAKING AFC TANK LC AFC OUTPUT CVBS OUTPUT NOT TO BE CONNECTED 2nd IF SOUND CHANNEL INPUT
Symbol VX P TSTG Supply voltage Tuner AGC voltage Power dissipation at TAMB 70 C Storage temperature rangeSymbol RTH(j-a) Parameter Junction-ambient thermal resistance Max. Value 80 Unit
ELECTRICAL CHARACTERISTICS (Tamb = 25oC, VCC 9V, IF input = 10mVRMS top sync, = 90%, Video = 5MHz, Sound carrier input = 1kHz, Audio ▒ 25kHz, Volume attenuation = 0dB, unless otherwise specified)Symbol SUPPLY Supply voltage Supply current V mA Parameter Test conditions Min. Typ. Max. Unit
ELECTRICAL CHARACTERISTICS (Tamb = 25oC, VCC 9V, IF input = 10mVRMS top sync, = 90%, Video = 5MHz, Sound carrier input = 1kHz, Audio ▒ 25kHz, Volume attenuation = 0dB, unless otherwise specified)
Symbol IF AMPLIFIER AGC range IF - sensitivity (RMS) R input differential C input Stray DEMODULATED VIDEO OUTPUT S/N video (BW = 5MHz) Intermodulation 1.07MHz (WH BL ) NRMS AGC open loop, Picture carrier = 0dB, Chrominance carrier = -3.2dB, Sound carrier -20dB IF inp. dB 58 Video out -3dB Guaranteed by process k pF Parameter Test conditions Min. Typ. Max. Unit
Detected video output peak to peak (positive) Top synchro output level Video Bandwidth with output filter Differential phase Differential gain White noise clamp White noise insertion Video output current capability Residual output carrier (RMS) AFC slope AGC CIRCUIT Maximum I charge Maximum I discharge ICH / IDISCH Ratio TUNER AGC Sinked Current Slope DEMODULATED AUDIO OUTPUT Detected output audio signal (RMS) Total harmonic distorsion Amplitude modulation rejection 2nd IF sound sensitivity -3dB FM detected audio signal (RMS) S+ N Thermal drift of volume Input resistance limiter Volume Control versus V9Referred to the video output see Figure At 77.8MHz With RLoad = 200k, see Figure
|Some Part number from the same manufacture ST Microelectronics, Inc.|
|TDA8214B H/v Processor For Low Cost TV|
|TDA8215B H/v Processor With Darlington Drive For Low Cost TV|
|TDA8217 Pal Decoder And Video Processor|
|TDA8218 Horizontal And Vertical Deflection Circuit|
|TDA8219 Pal/ntsc Decoder And Video Processor|
|TDA8222 Video & Sound if System With Video And Sound Switches|
|TDA9102C H/v Processor For TTL V.D.U.|
|TDA9102F H/v Processor For TTL V.d.u|
|TDA9102T TDA9102C/T H/v Processor For TTL V.d.u|
|TDA9103 Deflection Processor For Multisync Monitors|
|TDA9103-USER TDA9103 User's Manual Demonstration Board|
|TDA9105 Deflection Processor For Multisync Monitors|
|TDA9106 Low-cost Deflection Processor For Multisync Monitors|
|TDA9109A Low-cost I2C Controlled Deflection Processor For 15 And 17 Inch Multisync CRT Monitors|
|TDA9109SN Low-cost Deflection Processor For Multisync Monitors|
L200C : Adjustable Voltage And Current Regulator
M95010-MN3T/W : 4KBIT, 2KBIT And 1KBIT Serial Spi Bus EePROM With High Speed Clock
PSD913G1-C-90U : Flash In-system Programmable Isp Peripherals For 8-bit MCUs
M54HC85D1 : RAD HARD 4-bit Magnitude Comparator
TSV992AIYDT : Rail-to-rail Input/output 20 MHz GBP Operational Amplifiers
NAND01GR4A0CZA1 : 256/512mb/1gb (x8/x16, 1.8/3v, 528 Byte Page) NAND Flash Memories + 256/512mb (x16/x32, 1.8v) Lpsdram, MCP
M28W320ECB10N1T : 32mbit (2Mb x16) and 64mbit (4Mb x16) 3V Supply, Uniform Block, Secure Flash Memories
M95640-WMN6TP : 8K X 8 SPI BUS SERIAL EEPROM, DSO8 Specifications: Density: 66 kbits ; Number of Words: 8 k ; Bits per Word: 8 bits ; Bus Type: Serial ; Production Status: Full Production ; Data Rate: 10 MHz ; Supply Voltage: 5V ; Package Type: 2 X 3 MM, ROHS COMPLIANT, MLP-8 ; Pins: 8 ; Operating Range: Industrial ; Operating Temperature: -40 to 85
ST72F321BJ7T3 : 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP64 Specifications: Life Cycle Stage: ACTIVE ; Clock Speed: 16 MHz ; ROM Type: Flash ; Supply Voltage: 3.8 to 5.5 volts ; I/O Ports: 48 ; Package Type: TQFP, Other, 10 X 10 MM, PLASTIC, TQFP-64 ; Operating Range: Commercial ; Pin Count: 64 ; Operating Temperature: 0 to 70 C (32 to 158 F) ; Features: PWM
2SC982TM : NPN Epitaxial Type ( Printer Drive, Core Driver And Led Drive, Low Frequency Amplifier Applications ).
824BPSeries : Band Pass 8-bit Programmable 2-pole PaIR Filters. : The 824BP Series a 2-pole-pair digitally programmable precision band-pass active filter that provides high performance in a compact x 2" footprint. These new filters take advantage of the company's proprietary designs using surface-mount technology to provide a low profile, compact package in minimal board space. 824BP filters are factory tuned to one of three.
CLC5602 : Dual, High Output, Video Amplifier. The National CLC5602 has a new output stage that delivers high output drive current (130mA), but consumes minimal quiescent supply current (1.5mA/ch) from a single 5V supply. Its current feedback architecture, fabricated in an advanced complementary bipolar process, maintains consistent performance over a wide range of gains and signal levels, and has a linear.
CLC5802 : Dual Low-noise, Voltage Feedback op Amp. The is a dual op amp that offers a traditional voltage-feedback topology featuring unity-gain stability. Low noise and very low harmonic distortion combine to form a very wide dynamic-range op amp that operates within a power supply range to 12V. Each of the CLC5802's closely matched channels provides a 140MHz unity-gain bandwidth with a very low input.
INA116PA : ti INA116, Ultra Low Input Bias Current Instrumentation Amplifier. Ultra Low Input Bias Current INSTRUMENTATION AMPLIFIER q LOW INPUT BIAS CURRENT: 3fA typ q BUFFERED GUARD DRIVE PINS q LOW OFFSET VOLTAGE: 2mV max q HIGH COMMON-MODE REJECTION: 10) q LOW QUIESCENT CURRENT: 1mA q INPUT OVER-VOLTAGE PROTECTION: ▒40V The is a complete monolithic FET-input instrumentation amplifier with extremely low input bias current.
LM2904 : Low Power Dual Op-amp. s INTERNALLY FREQUENCY COMPENSATED s LARGE DC VOLTAGE GAIN 100dB s WIDE BANDWIDTH (unity gain): 1.1MHz ESSENTIALLY INDEPENDENT OF SUPPLY VOLTAGE LOW INPUT BIAS CURRENT: 20nA (temperature compensated) LOW INPUT OFFSET CURRENT: 2nA INPUT COMMON-MODE VOLTAGE RANGE INCLUDES GROUND DIFFERENTIAL INPUT VOLTAGE RANGE EQUAL TO THE POWER SUPPLY VOLTAGE LARGE.
LT6301 : LT6301, Dual 500mA, Differential XDSL Line Driver in SSOP-28. LT6301 Dual 500mA, Differential xDSL Line Driver in 28-Lead TSSOP Package Drives Two Lines from One Package Exceeds All Requirements For Full Rate, Downstream ADSL Line Drivers Power Enhanced 28-Lead TSSOP Package Power Saving Adjustable Supply Current ▒ 500mA Minimum IOUT ▒ 11.1V Output Swing, 100 ▒10.9V Output Swing, = 250mA Low Distortion: 1MHz,.
MAX4173F : Low-Cost, SOT23, Voltage-Output, High-side Current-sense Amplifier. The MAX4173 low-cost, precision, high-side currentsense amplifier is available in a tiny SOT23-6 package. It a voltage output that eliminates the need for gain-setting resistors and it is ideal for today's notebook computers, cell phones, and other systems where current monitoring is critical. High-side current monitoring is especially useful in battery-powered.
MAX4659 : High-Current, 25, Spdt, CMOS Analog Switches. The MAX4659/MAX4660 are medium voltage CMOS analog switches with a low on-resistance of 25 max specifically designed to handle large switch currents. With a switch capability to 200mA peak current and 150mA continuous current (MAX4660), and to 150mA peak current and 75mA continuous current (MAX4659), these parts can switch loads as low as 50. They can replace.
NJM4556A : Dual High Current Operational Amplifier.
OPA3691ID : ti OPA3691, Triple Wideband Current Feedback Operational Amplifier With Disable.
RF2155 : 3V Programmable Gain Power Amplifier. Typical Applications Analog Communication Systems 900MHz Spread Spectrum Systems 400MHz Industrial Radios Product The a 3V medium power programmable gain amplifier IC. The device is manufactured on an advanced Gallium Arsenide Heterojunction Bipolar Transistor (HBT) process, and has been designed for use as the final RF amplifier in analog cellular.
TDA4670 : Picture Signal Improvement (psi) Circuit. Product Supersedes data of May 1991 File under Integrated Circuits, IC02 1996 Dec 11 Luminance signal delay from 1100 ns (minimum step 45 ns) Luminance signal peaking with selectable symmetrical overshoots or 5 MHz peaking centre frequency and selectable degree of peaking 0, +3 and +6 dB) Selectable noise reduction by coring Handles negative and positive.
TLC25L4 : . A-Suffix Versions Offer 5-mV VIO B-Suffix Versions Offer 2-mV VIO Wide Range of Supply Voltages 16 V True Single-Supply Operation Common-Mode Input Voltage Includes the Negative Rail Low Noise. 25 nV/Hz Typ = 1 kHz (High-Bias Version) symbol (each amplifier) The IN + and TL25M4B are low-cost, low-power quad OUT operational amplifiers designed to operate.
TPA0253DGQ : ti TPA0253, Mono, Low Power, Class-ab Audio Amplifier With Stereo Headphone Driver-summing Inputs.
TDA8922B : 2 x 50 W class-D power amplifier The TDA8922B is a high efficiency class-D audio power amplifier with very low dissipation. The typical output power is 2 x 50 W. The device is available in the HSOP24 power package and in the DBS23P through-hole power package. The amplifier operates over a wide supply voltage range from +-12.5 V to +-30 V and consumes.
TSV321 : General Purpose, Input/Output Rail-to-Rail Low Power Operational Amplifiers.
OPA2376 : Precision, Low Noise, Low Quiescent Current Operational Amplifier The OPA376 family represent a new generation of low-noise operational amplifiers. Rail-to-rail input, low offset (5ÁV typ), low noise (7.5nV/Hz), quiescent current less than 1mA max, and a 5.5MHz bandwidth make this part very attractive for a variety of precision and portable applications.
STG4158 : Switch (NEATSwitch) Low voltage 0.6 ohm typ single SPDT switch with break-before-make feature and 15 kV ESD protection.
ADG854 : 0.5 ? CMOS 1.8 V TO 5.5 V Dual SPDT/2:1 MUX Mini LFCSP Package The ADG854 is a low voltage CMOS device containing two independently selectable single-pole, double-throw (SPDT) switches. This device offers ultralow on resistance of less than 0.8 ? over the full temperature range. The ADG854 is fully specified for 5.5 V, 3.3 V, and 2.5 V supply operation.