Details, datasheet, quote on part number: LTC7821EUHPBF
PartLTC7821EUHPBF
Category
TitleIC REG CTRLR BUCK HYBRID 32QFN
Description
CompanyLinear Technology Corporation
DatasheetDownload LTC7821EUHPBF datasheet
  
LTC7821EUHPBF photo

Others parts numbering
LTC7821IUHPBF

 

Features, Applications

DESCRIPTION

The LTC®7821 uses a proprietary architecture that merges a soft switching charge pump topology with a synchronous step-down converter to provide superior efficiency and EMI performance compared to traditional switching architectures. In a typical to 12V application, efficiency of greater than 97% is attainable with the LTC7821 switching at 500kHz. The same efficiency can only be achieved with a traditional controller switching at one-third the frequency. Higher switching frequencies allow the use of smaller inductances that yield faster transient response and smaller solution size. The LTC7821 can be easily paralleled to provide higher output currents with its accurate current sharing capability and frequency synchronization function.

All registered trademarks and trademarks are the property of their respective owners. Protected by U.S. patents, Including 9484799.

Wide VIN Range: 72V (80V ABS Max) Soft Switching for Low Noise Operation Phase-Lockable Fixed Frequency 1.5MHz ±1% Output Voltage Accuracy RSENSE or DCR Current Sensing Programmable CCM, DCM, or Burst Mode® Operation CLKOUT Pin for Multiphase Operation Short Circuit Protected EXTVCC Input for Improved Efficiency Monotonic Output Voltage Start-Up Optional External Reference × 5mm) QFN Intermediate Bus Converters High Current Distributed Power Systems Telecom, Datacom, and Storage Systems

APPLICATIONS

100 1µF VIN_SENSE VIN 0.22µF BOOST1 TIMER BG1 BOOST2 MID INTVCC 10k FAULT PGOOD PINS NOT SHOWN IN THIS CIRCUIT: CLKOUT TEMP RUN HYS_PRGM MODE/PLLIN TRACK/SS 8V 10k FAULT PGOOD SW3 BG2 INTVCC PGND EXTVCC VFB ISNS+ ISNS­ 60.4k

Input Supply Voltage (VIN, VIN_SENSE)....... to 80V Top Side Driver Voltages to 46V Switch Voltages to 40V MID, MID_SENSE....................................... to 6V ISNS+, ISNS to 40V (ISNS+ ­ ISNS ­).......................................................±0.6V EXTVCC...................................................... to 40V TEMP, FREQ, EXT_REF, VFB.................. ­0.3V to INTVCC HYS_PRGM, ITH, RUN, TRACK/SS....... ­0.3V to INTVCC FAULT, PGOOD........................................... to 80V TIMER, MODE/PLLIN............................ ­0.3V to INTVCC Peak Output Current................................100mA Operating Junction Temperature Range (Notes to 125°C Storage Temperature Range.................. to 150°C

TJMAX = 7.3°C/W EXPOSED PAD (PIN 33) IS GND, MUST BE SOLDERED TO PCB

PART MARKING* 7821 PACKAGE DESCRIPTION × 5mm) Plastic QFN × 5mm) Plastic QFN TEMPERATURE RANGE to 125°C

Consult LTC Marketing for parts specified with wider operating temperature ranges. *The temperature grade is identified by a label on the shipping container. For more information on lead free part marking, go to: http://www.linear.com/leadfree/ For more information on tape and reel specifications, go to: http://www.linear.com/tapeandreel/. Some packages are available in 500 unit reels through designated sales channels with #TRMPBF suffix.

The l denotes the specifications which apply over the specified operating junction temperature range, otherwise specifications are = 25°C (Note 2). VIN = VIN_SENSE = 48V, VRUN = 5V, EXTVCC = 9V, EXT_REF = 5.6V unless otherwise noted.

SYMBOL VIN PARAMETER Input Voltage Range Output Voltage Range VFB IFB VREFLNREG VLOADREG gm IVIN Regulated Feedback Voltage Feedback Current Reference Voltage Line Regulation Output Voltage Load Regulation (Note 4) ITH Voltage (Note 5) (Note 4) VIN to 72V (Note 5) (Note 4) ITH Voltage to 0.7V ITH Voltage to 1.6V ITH = 1.15V; Sink/Source 5µA (Note 5) (Note 6) VRUN = 0V VIN = 20V, VMID = VMID_SENSE = 10V VIN = 20V, VMID = VMID_SENSE = 5V (Note 6) VRUN = 0V, VEXT_REF = 0V (Note 6)

Transconductance Amplifier gm Input DC Supply Current Normal Mode Shutdown Precharging Phase

IVIN_SENSE IEXTVCC IMID IMID_SENSE VUVLO VUVLO_HYST VSENSE ISNS+/ITRACK/SS VRUN_ON IRUN VRUN_HYST VEXT_REF_UC VEXT_REF_LC VSEL_EXT_REF IEXT_REF VTEMP_TRIP VTEMP_TRIP_HYST ITEMP VBSTUVLO VBSTUVLO_HYST TOUT

Input DC Supply Current Normal Mode Shutdown Input DC Supply Current MID Pin Current MID_SENSE Pin Current VIN Undervoltage Lockout UVLO Hysteresis Current Sense Threshold ISNS+ and ISNS­ Pin Current Soft-Start Charge Current RUN Pin On Threshold RUN Pin Current RUN Pin Hysteresis EXT_REF Upper Clamp Limit EXT_REF Lower Clamp Limit EXT_REF De-Select Threshold (Ramping Up) EXT_REF Pin Current TEMP Pin Trip Point, Rising TEMP Pin Trip Point Hysteresis TEMP Pin Current Undervoltage Lockout (BOOST1-SW1), (BOOST2- VMID) and (BOOST3-SW3) Bootstrap Undervoltage Lockout Hysteresis TEMP Trip TimeOut

VIN Ramping Up VISNS­ = 0V VISNS+ = VISNS­ = 12V VTRACK/SS = 0V VRUN Rising VRUN = 0V (Note 5) (Note 5) VEXT_REF = 0.6V


 

Some Part number from the same manufacture Linear Technology Corporation
LTC7821IUHPBF
LT8364HDEPBF

LTC’s LT8364 is a current mode DC/DC converter with a 60 V, 4 A switch operating from a 2.8 V to 60 V input. This converter has a single feedback pin architecture which is capable

LT8364HMSEPBF
LT8364EDEPBF

LND3844B : Current Modepwm Controller , Uvlo of 16 V(ON), 10 V (OFF) @ 100% Duty Cycle

LT1022 : LT1022, High Speed, Precision JFET Input op Amp

LT1215ACN8 : LT1215, 23MHz, 50V/µs, Single Supply Dual Precision op Amps

LT1791LT1791 : LT1791, 60V Fault Protected Full-duplex Transceiver, 15kV Esd, SO-14

LTC1690C : Differential Driver And Receiver PaIR With Fail-safe Receiver Output

LTC2635HMSE-LMO12#PBF : Quad 8-Bit I2C VOUT DACs With 10ppm/°C Reference The LTC2635 is a family of quad 12-, 10-, and 8-bit voltage-output DACs with an integrated, high-accuracy, low-drift reference in a 16-pin QFN or a 10-lead MSOP package. It has rail-to-rail output buffers and is guaranteed monotonic. The LTC2635-L ha

LTC2446CUHF : 24-bit High Speed 8-channel „Ä„Ņ ADCs with Selectable Multiple Reference Inputs

LTC2955IDDB-1#TRMPBF : Pushbutton On/Off Controller With Automatic Turn-On The LTCĀ®2955 is a micropower, pushbutton on/off controller that manages system power by generating a clean enable output from the supply monitor input and the debounced pushbutton input. It features an interrupt output that notifies the system of

LT1460KCS3-3.3#TRPBF : 10V LT1460HCS3-10, 10V Micropower Series Reference in SOT-23

LT3060ETS8-1.5#PBF : 0.6 V-44.5 V ADJUSTABLE POSITIVE LDO REGULATOR, 0.51 V DROPOUT, PDSO8 Specifications: Regulator Type: Low Dropout ; Output Polarity: Positive ; Output Voltage Type: Adjustable / Variable ; Package Type: Other, PLASTIC, MO-193, TSOT-23, 8 PIN ; Life Cycle Stage: ACTIVE ; Output Voltage: 0.6000 to 44.5 volts ; IOUT: 0.1000 amps ; Dropout Voltage: 0.5100 volts

LT3585EDDB-2 : 1.3 A BATTERY CHARGE CONTROLLER, PDSO10 Specifications: Configuration / Function: SINGLE ; Package Type: Other, 3 X 2 MM, LEAD FREE, PLASTIC, MO-229WECD-1, DFN-10 ; Life Cycle Stage: ACTIVE ; IOUT: 1.3 amps ; VIN: 3 volts ; Operating Temperature: 0 to 85 C (32 to 185 F)

 
0-C     D-L     M-R     S-Z